KTM 690 SMC 2008, Руководство по ремонту

Страница: 86 / 227

14/LIGHT SYSTEM, INSTRUMENTS
84
15.6
Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically at a distance

in front of the wall.
Guideline
Distance

5 m (16 ft)
–
The rider, with luggage and a passenger if applicable, now sits down on the motor-
cycle.
–
Switch on the low beam.
–
Check the headlight setting.
For a ready-to-operate motorcycle with a rider, and with luggage and a passenger
if applicable, the light-dark boundary must lie exactly on the lower mark.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 84)
15.7
Adjusting the headlight range
–
Check the headlight setting. ( p. 84)
800084-10
–
Turn adjusting screw

to adjust the headlight range.
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (made in: Checking headlight adjustment).
Info
Turn clockwise to increase the headlight range; turn counterclockwise to
reduce the headlight range.
If you have a heavy payload, you will need to correct the headlight range.
15.8
Removing the headlight mask with the headlight
–
Switch off all power consumers and switch off the engine.
100296-11
–
Cover the fender with a cloth to protect it from damage.
–
Remove screws

on the left and right.
–
Tip the headlight mask forward and pull it off in an upward direction.
100294-10
–
Disconnect the connectors of turn signals

and headlight

.
–
Put down the headlight mask.