KTM 690 SMC 2008, Руководство по ремонту

Страница: 120 / 227

30/ENGINE - WORK ON INDIVIDUAL PARTS
118
300228-10
–
Remove the small camshaft bearing

using the special tool.
Insert for bearing puller (15112018100) ( p. 208)
Bearing puller (15112017000) ( p. 208)
300229-10
–
Press in the small camshaft bearing as far as possible using the special tool

.
Push-in drift (75029044020) ( p. 213)
300230-10
–
Press in the large camshaft bearing as far as possible using the special tool

.
Push-in drift (75029044010) ( p. 213)
–
Install the rocker arm. ( p. 121)
18.22
Removing valves
300115-10
–
Take the shims

out of the valve spring retainers and lay them to one side accord-
ing to their normal built-in position.
300116-10
–
Pretension the valve springs using the special tool.
Valve spring compressor (59029019000) ( p. 209)
Valve spring mounting device (78029060000) ( p. 216)
–
Remove valve keys and release tension on the valve springs.
–
Remove spring retainers and spring.
–
Pull the valve down and out of the valve guide, remove the valve stem seal and
valve spring retainer.
300117-10
–
Mark the valves according to their normal built-in position.
Info
Place the valve into a box according to the installation position and label the
box.