KTM 690 SMC 2008, Руководство по ремонту

Страница: 25 / 227

01/FORK, TRIPLE CLAMP
23
200655-11
–
Install dust boot

.
200674-10
–
Grease the O-ring of valve

of the rebound damping.
Lubricant (T158) ( p. 206)
–
Mount valve

of the rebound damping with the spring on adjusting tube

.
–
Mount valve

of the rebound damping from below in cartridge

.
The adjusting tube protrudes 5 mm from the cartridge and can be pressed in
against the resistance of the spring.
The adjusting tube protrudes more than 7 mm from the cartridge and cannot
be pressed in against the resistance of the spring.
–
Screw on fluid barrier

as far as it will go.
Info
The fluid barrier must be tightened as much as possible. Do not use tools.
200675-10
–
Install the special tool on the cartridge.
Gripping tool (T14026S1) ( p. 218)
Info
The special tool must be used to prevent the adjusting tube being lifted and
thus to prevent oil from reaching the piston rod.
200683-10
–
Push the cartridge with the spring seat and preload spacer into the inner tube.
–
Mount screw

of the cartridge with the seal ring and tighten it.
Guideline
Cartridge screw M12x1 25 Nm
(18.4 lbf ft)
200682-10
–
Grease and mount screws

of the axle clamp but do not tighten.
Lubricant (T152) ( p. 207)