13/BRAKE SYSTEM
80
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
100259-10
–
Stand the vehicle upright.
–
Remove screw cap
with the washer and membrane
.
–
Add brake fluid to the
MAX
mark.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the washer and membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
14.13
Changing the rear brake fluid
Warning
Skin irritation
Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
301893-10
–
Remove screw cap
with washer
and membrane
.
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
302043-10
–
Pull off dust cap
and connect a commercially available suction device (standard
workshop equipment).
–
Release bleeder screw
and draw out the old brake fluid.
Info
During suction, ensure that the brake fluid reservoir is always filled with a
sufficient amount of fresh brake fluid.
–
Tighten the bleeder screw. Remove the suction device and mount the dust cap.
Содержание 690 SMC 2008
