KTM 690 SMC 2008, Руководство по ремонту

Страница: 164 / 227

41/THROTTLE VALVE BODY
162
601133-10
–
Carefully close the throttle valve with your finger and hold it.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Basic position - voltage "THAD" 0.50… 0.54 V
» If the displayed value is not equal to the setpoint value:
–
Loosen screw

.
–
Adjust the throttle position sensor circuit A

by turning to the specified
value.
–
Tighten screws

.
–
Press "Continue" .
–
Release the throttle valve.
–
Open and close the throttle grip fully ten times.
The "Continue" button appears.
–
Press "Continue" .
601133-11
–
Carefully close the throttle valve again with your finger and hold it.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Basic position - voltage "THAD" 0.50… 0.54 V
» If the displayed value is not equal to the setpoint value:
–
Repeat the setting.
–
Use
"Continue"
to start the
"Adjusting the emergency position of the throttle valve"
menu.
–
Release the throttle valve.
–
Fix screws

with locking varnish.
601134-10
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Emergency running position - volt-
age
"THAD"
0.70… 0.74 V
» If the displayed value is not equal to the setpoint value:
–
Screw off fuse cover

.
–
Loosen nut

.
–
Adjust the emergency running position by turning screw

to the specified
value.
–
Tighten nut

.
–
Mount and tighten fuse cover

.