KTM 690 SMC 2008, Руководство по ремонту

Страница: 124 / 227

30/ENGINE - WORK ON INDIVIDUAL PARTS
122
18.30
Checking the clutch
–
Dismantle the antihopping clutch. ( p. 121)
0 0 9 9
0 0 bk bk
0 0 7 7
0 0 1 1
0 0 2 2
0 0 3 3
0 0 4 4
0 0 5 5
0 0 6 6
0 0 8 8
0 0 bl bl
0 0 bm bm
0 0 bn bn
0 0 bo bo
300123-01
–
Check pressure piece

for damage and wear.
» If there is damage or wear:
–
Replace the pressure piece.
–
Check axial bearing

for damage and wear.
» If there is damage or wear:
–
Change the axial bearing.
–
Place push rod

on a level surface and check it for run-out.
» If there is run-out:
–
Change the push rod.
–
Check the length of clutch springs

.
Clutch spring - length 31.5… 33.5 mm (1.24… 1.319 in)
» If the clutch spring length is less than the specified value:
–
Change all clutch springs.
–
Check the contact surface of pressure cap

for damage and wear.
» If there is damage or wear:
–
Change the pressure cap.
–
Check the contact surfaces of the clutch facing discs in the outer clutch hub

for wear.
Clutch cage - contact surface of clutch facing discs
≤
0.5 mm (
≤
0.02 in)
» If the contact surface is very worn:
–
Change the clutch facing discs and the outer clutch hub.
–
Check needle bearing

and supporting plate

for damage and wear.
» If there is damage or wear:
–
Replace the needle bearing and supporting plate.
–
Check intermediate discs

for damage and wear.