KTM 690 Enduro R 2018, Руководство по ремонту

Страница: 16 / 311

—
Turn the
emergency
OFF switch
to the
position ©.
-—
Switch
on
the
ignition by turning
the
ignition key
to
position
ON ©).
~”
After you switch
on
the
ignition,
you can
hear the
fuel
pump
working
for about
two
seconds. The function check
of the combination instrument is
run
at the
same
time.
()
”
The
ABS warning lamp lights
up and goes back out after
starting
off.
B00103-10
—
Shift
gear to neutral.
&
The green idle indicator
lamp
N
lights
up.
—
Press the electric
starter
button @.
e
Info
il
Do not press the
electric
starter button
until
the
combi-
nation instrument function check is finished.
When
starting,
DO
NOT openthe throttle. If you open
the throttle
during
the
starting procedure,
fuel is
not
injected by
the
engine management system
and the
engine
cannot
start.
Press the starter for
a
maximum of 5 seconds. Wait for
a
least 5 seconds before
trying again.
This
motorcycle
is
equipped
with
a
safety starting
sys-
tem.
You
can
only
start
the
engine
if the transmission
is in neutral
or
if the clutch lever is
pulled
when
a
gear
is
engaged.
If the side stand is folded
out
and you shift
into gear and release the clutch, the engine stops.
—
Take the
weight
off the side stand and
swing
it back up with
your foot
as
far
as
it will go.
Switching
off ABS
KTM recommends
riding
with ABS at all times.
However,
situa-
tions may arise in which ABSis not
advantageous.
Condition
Vehicle
stationary, engine running.
—
Press button
@
for 3
-
5 seconds.
&
The
ABS
warning
lamp
starts
flashing;
ABS
is
deactivated.
Danger
Danger
of
poisoning
Exhaust gases
are
toxic and
inhaling
them
may
result
in unconsciousness and death.
-
Always make
sure
there is sufficient ventilationwhen
running
the
engine.
-
Use
an
effective exhaust extraction system
when
starting
or
running the
engine
in
an
enclosed space.
e
Info
Press the
starter
for
a
maximum of 5 seconds. Wait for
a
least 5 seconds before
trying again.
Condition
14