KTM 690 Enduro R 2018, Руководство по ремонту

Страница: 158 / 311

17.4.1.
Working
on
the
right
section of the
engine
case
305649-10
305650-10
305651-10
Remove oil nozzle
@.
Remove bearing retainers
So
of the main shaft
bearing,
o
of
the countershaft
bearing
and
86
of the shift drum
bearing.
Remove
any remnants of
sealing compound
and clean the
sec-
tion of the
engine
case
thoroughly.
Pull the dowels out of the
housing.
Warm the section of the
engine
case
in
an oven.
Guideline
150 °C
(302 °F)
Knock the
section
of the
engine
case
against
a
level wooden
board. This will
cause
the
bearings
to
drop
out
of the
bearing
seats.
Info
Any bearings
that remain in the section of the
engine
case
must
be
removed
using
a
suitable tool.
Removeoil nozzle
Qe.
Remove the
cover
plate
@
forthe oil
return line.
Press out shaft seal
ring
@®
of the crankshaft from
the
inside
to
the outside.
Removeshaft
seal
rings
o
of the
water pump.
Press in the shaft seal
ring
@
of the crankshaft from the out-
side
to
the inside with the
open
side facing
in.
Info
The shaft seal ring
must
be flush
on
the
outside.
Press in the shaft seal
rings
of the
water
pump with the open
side
facing
out
so
that
it is flush.
Warm the section of the
engine
case
again.
Guideline
150 °C
(302 °F)
Insert the
new
cold
bearings
into the
bearing
seats of the hot
engine
case
section
and,
if necessary,
use a
suitable
press
drift
to
push
the
bearings
from the
inside
to the
outside, all
the
way
to the
stop
or
so
it is flush.
Info
Shift shaft
bearing
9
must be
pressed in
from the
outside to the inside until it is flush.
When
pressing in,
ensure
that the section of the
engine
case
lies flat in order prevent damage.
Only
press the
bearings
in
using
the
outer
bearing
race;
otherwise,
the
bearings will
be
damaged
when theyare
pressed
in.
156