KTM 450 XC-W SIX DAYS USA 2010, Руководство пользователя

Страница: 50 / 118

MAINTENANCE WORK ON CHASSIS AND ENGINE
48
9.36
Handlebar position
0 0 B B 0 0 B B
0 0 A A 0 0 A A
400223-11
On the upper triple clamp, there are 2 holes at a distance of

to each other.
Distance

between holes 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of

from the center.
Distance

between holes 3.5 mm (0.138 in)
The handlebar supports can be mounted in 4 different positions.
9.37
Adjusting handlebar position
x
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0 0 2 2
0 0 1 1
0 0 2 2
0 0 1 1
400223-10
–
Remove the four screws

. Remove the handlebar clamps. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws

. Remove the handlebar support.
–
Place the handlebar support in the required position. Fit and tighten the two screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebars.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Fit and evenly tighten the four screws

.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
9.38
Checking throttle cable route
500152-10
–
The two throttle cables must run parallel behind the handlebar down to the frame.
They must be routed directly to the right of the frame above the tank bracket
towards the carburetor.