KTM 450 SMR 2021, Руководство пользователя

Страница: 51 / 139

SERVICE WORK ON THE CHASSIS 11
49
H01167-01
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust steering head bearing play. ( p. 49)
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust steering head bearing play. ( p. 49)
–
Check the steering head bearing and adjust if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 42)
11.12 Adjusting steering head bearing play
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 42)
–
Remove the handlebar cushion.
S03017-10
Main work
–
Loosen screws
1
.
–
Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering
head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
Mount and tighten screw 2 .
Guideline
Screw, top
steering stem M8 20 Nm (14.8 lbf ft)
Loctite ® 243™
–
Tighten screws
1
.
Guideline
Screw, top triple
clamp M8 17 Nm (12.5 lbf ft)
–
Check steering head bearing play. ( p. 48)
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. ( p. 42)