KSB Hya-Solo DV Series, Инструкция по установке и эксплуатации

Страница: 25 / 56

Section 5.9.1 Page 15)
Parameterisation (
⇨
Section 8.7.6 Page 41)
6.7.6 Analog output
Terminal strip P4, terminals 11 and 12 (
⇨
Section 5.9 Page 15)
PumpDrive is equipped with an analog output, whose output value can be
parameterised via the control panel depending on the digital inputs.
Parameterisation (
⇨
Section 8.7.7 Page 41)
6.7.7 LON module
The plug-on LON interface module is connected to an available on-site LON network.
The LON interface is equipped with a FTT-10A transceiver (Free Topology
Transceiver).
The following settings parameters can be set:
▪
Start
▪
Stop
▪
Setpoint for settings
The following monitoring parameters can be set:
▪
Actual value
▪
Speed
▪
Pressure (if connected to sensor)
▪
Pump status
▪
Pump fault or malfunction
▪
Operating hours
▪
Energy input
▪
Pump input power
Further details and parameters can be found in the LON literature for PumpDrive;
refer to the Product Catalogue on the KSB web site.
The LON literature is based on the LONMARK Functional Profile Pump Controller V
1.0 - SFPTpumpController standard.
The LON interface is put into service on site.
6 Installation at Site
Hya®-Solo DV 25 of 56