
B.Main voltage range and fuse:
Before inserting the main plug into the wall socket, make sure that the unit is
compatible with local main voltage.
Warning: The equipment shall be disconnected from all voltage sources
when a fuse is to be replaced.
The main (line) fuseholder is located on the rear panel in the main (line)
input socket. When the main (line) fuse needs replacing, proceed as follows:
-
Disconnect the unit from the line.
-
Remove the cover of the fuseholder by means of a small screwdriver.
-
Fit a new fuse of the correct rating and refit the cover of the fuseholder.
The fuse will be 2A/250V delay action type.
4. Setting Up
It is fairly simple to install this equipment. Just unpack the Bonart
Scaler and connect the components as shown in the figure below.
Note:
When unpacking the box, check ART-SP2 for any damages. If damaged,
please contact your dealer immediately. Enter the unit serial number on your
warranty card mail it within 10 days after setting up the machine.
Figure 3. ART-SP2 setting up diagram
7