Krone Swadro TC 880, Руководство по эксплуатации

Страница: 83 / 128

Settings
83
12.1 Setting the Rotor Inclination
The rotor pitch angle has been set at a transverse angle to the chassis in the factory. If the
crops are not picked up properly, the working quality can be improved by adjusting the rotor
pitch.
The rotor pitch angle is adjusted for each rotor via the guide wheels at the chassis. The best
results are achieved if the rotor pitch adjustment ensures the tines are closer to the ground level
when outputting the crops than at the start when picking up the crops.
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
12.1.1 Rotor chassis (serial)
I
III
+
II
1
SW9000020_1
Fig. 50
Setting the rotor inclination:
Pos. I = Reducing rotor inclination
Pos. II = Increasing rotor inclination
Do not step under the raised rotors.
• To do this, raise the outrigger arms until the changeover work can be performed.
• To set rotor inclination, dismount the rear guide wheels and move them in the hole pattern.
Vernier adjustment via eccentric cam (1):
−
= Reducing rotor inclination
+ = Increasing rotor inclination
Do not step under the raised rotors.
•
Raise the outrigger arms until the changeover work can be performed.
• Loosen the nut of the wheel bolt.
• Turn the eccentric (1) to set the rotor inclination.
• Tighten the nut of wheel bolt.
Note
If the forage is heavy, adjust the inner running gear as low as possible!