Krone Comprima F 125, Оригинальное руководство по эксплуатации

Страница: 67 / 234

V - 19
Basic Settings and Operation
5.8.7 Adjusting the Feed Position
An optimum adjustment of the feed position has been
reached when the feeder plate (3) of the net has moved
out just far enough that there is still a small gap between
the feeder plate (3) and the conveyor roller (4) and
dimension A between the pivot point of the ratchet
mechanism (1) and the adjusting lever (2)
A = 285 mm.
If this is not the case, please proceed as follows:
• Bring up the "Motor Position Sensor Test" menu on the
control unit (in the Comfort version) or "Motor Position
Setting" (in the Medium version).
• Move the engine out over the control unit just enough
so there is still a small gap between the feeder plate (3)
and the conveyor roller (4) and dimension A between
the pivot point of the ratchet mechanism (1) and the
adjusting lever (2) A = 285 mm. Once dimension
A is reached, save the supply position.
5 3
5 4
RPM00014_1
A
5 1
5 2
5.8.6 Adjusting the Cut-off Position
The cut-off position has been reached, when the ratchet
mechanism (1) is raised and dimension A between the
ratchet mechanism (1) and the adjusting lever is (2)
A= 410 mm.
If this is not the case, please proceed as follows:
• Bring up the "Motor Position Sensor Test" menu on the
control unit (in the Comfort version) or "Motor Position
setting" (in the Medium version).
• Move the engine in over the control unit until dimension
A between the pivot point of the ratchet mechanism (1)
and the adjusting lever (2) A = 410 mm. Once
dimension A=405 mm is reached, save the cut-off
position.
• Adjust the cable (3) to dimension B = 365 mm.
If the net is not cut off by practical use, the
dimension must be set to 360 mm.
A
B
RPN00044
1
2 3