KREMLIN REXSON
Page 3
Manual : 573.191.112
Dear Customer, You are the owner of our new CYCLOMIX
TM
MICRO mixing machine and we would
like to take this opportunity to thank you.
To make sure your investment will provide full satisfaction, special care has been taken by KREMLIN
during all designing and manufacturing processes. To obtain the best result, safe and efficient
operation of your equipment, we advice you to read and make yourself familiar with this instruction
and service manual.
1. GENERAL SAFETY INSTRUCTIONS
The CYCLOMIX
TM
MICRO mixing machine shall be installed outside the explosive
area. It shall be installed in a safe area (non-explosive area according to the ATEX
directive - refer to § 6).
The display unit must be moved 1 m / 3.3 ft away from the fluid module and not be
installed above that one.
WARNING : Any misuse of the equipment or accessories can damage them, result in serious body
injury, fire or explosion hazard and reduce the equipment working life. Read carefully the safety
instructions hereafter.
The personnel involved in operating and servicing this equipment must be aware of all safety requirements
stated in this manual. The workshop supervisor must be certain that the personnel has perfectly
understood the safety instructions and complies with them.
Read all instruction manuals as well as the tags of the equipments before operating the equipment.
Read local safety instructions and comply with them.
INSTALLATION REQUIREMENTS
Â
Ground the equipments.
Use the equipment only in a well-ventilated area to prevent from serious body injuries, fire and
explosion hazards. Do not smoke in the spray area.
Never stock paints and solvents in the spray area. Always close the pots and the tins.
Keep the spray area clean and free from debris (solvent, rags,…).
Read paint and solvent manufacturer's technical instructions.
Spraying of some materials may result in hazardous working conditions. To protect the operator,
respirator mask, hand cream and glasses are required (Refer to chapter "Safety equipment" of
KREMLIN selection guide).
EQUIPMENT REQUIREMENTS
The operating pressure of these equipments is particularly high. Consequently, some precautions must
be taken in order to prevent from accidents and from unsafe working conditions.
Â
Never exceed the components maximum working pressure of the equipment.
HOSES
Do not use hoses with a maximum burst-proof pressure less than four times the maximum service
pressure of the pump (see data sheet).
Be certain hoses are not crimped, leaking and not unrolled.
Be certain hoses are in good conditions and showing no evidence of damage.
Â
Use only air hose with static conductor to connect the pump with the spray gun.
All fittings must be tight and in good condition.
PUMP
Â
Ground the equipment (use the connection on the pump).
Do not use any product or solvent incompatible with the pump components.
Use the appropriate solvent for the material being sprayed to increase the equipment working life.
