KREMLIN REXSON
Page 19
Manual : 573.191.112
9. APPLICATION PROGRAMMING (F3)
To alter the parameters of the CYCLOMIX
TM
MICRO, go to F3, then validate. To shift from a parameter to
another, use the arrows
or
.
Select the parameter to alter. Depress the key
, then the arrows
or
to increase or decrease the
value. Activate
to validate the new value or ESC to cancel.
To quit a parameter, activate
ESC
.
To quit the PARAMETERS menu, activate
ESC
.
When using a 3 shades' machine, you must select the shade and alter later on the parameters.
The parameters are pre-programmed in the factory. They must be modified (by an authorized person) to
adapt themselves to the material).
PASSWORD
When you start the machine for the first time the access code of the menu `Parameters' is deactivated,
everyone is able to modify the machine’s parameters.
To activate this access code you have to :
- enter in the parameter 0 of the menu F3 :
)
Æ
« key
»
Æ
3
Æ
« key
». The code
‘
’
appears, it’s the code present by default in the machine.
- change the code by using the arrows
or
and the «key
» for each digit which compose this
code.
Once the access code was validated, the access is protected by the password. Only the people who
know this password and those which know the administrator code
‘
’
will be able to reach the
menu `Parameters'.
Each time a user wants to enter in the menu 'Parameters' the password will be required:
&
.
The user shall enter the password by using the arrows
or
and the «key
» for each digit
which compose this code :
- If the entered code is correct, the following fonts
appear.
- If the entered code is incorrect, the word ‘
(UURU
appears and the machine allows you to enter the
password again (Press 'Esc' to return to the principal menu).
If you want to desactivate the password, you just have to parameterise the code
‘
’
again as
access code.
PROCEDURE TO GET THE VERSION NUMBER OF THE ELECTRONIC CARD
- Install the magnet on the
OK
key,
- Start the machine.
