KREMLIN REXSON
Page 4
Manual : 573.191.112
GUN
Never wipe the end of the tip with the fingers.
Always depressurize air and fluid hoses before carrying out any servicing on the gun.
Never point the spray gun at anyone or at any part of the body.
CYCLOMIX
TM
MICRO
Â
Do not install the machine in an explosive area. It shall be in a safe area (non explosive
area).
Â
The display unit must be moved 1 m / 3.3 ft away from the fluid module and not be installed
above that one.
Â
Connect the control box to the mains supply fitted with a ground.
Â
The fluid module is fitted with a ground. Connect the ground cable to earth.
Â
Do not use any product or solvent incompatible with the machine components.
Â
Use the appropriate solvent for the material being sprayed to increase the equipment
working life.
Â
Wear protective glasses to protect the operator from possible discharges during the
handling of the CYCLOMIX
TM
MICRO machine test valves.
Â
Do not use electrostatic spraying for water-based paints with a resistivity lower than 5 M
:
.
MAINTENANCE REQUIREMENTS
Guards (air motor cover, coupling shields, connectors,…) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
Â
Never modify these equipments.
Check them daily, keep them in a good condition and replace the worn parts
only with KREMLIN
parts.
Before cleaning or removing components of the equipment, it is compulsory :
1 - to stop the air supply,
2 - to open the gun fluid circuit to depressurize the hoses,
3 - to shut off the machine electrical supply,
4 - to open the drain valves.
