Kratki LEO Series, Инструкция по установке и эксплуатации

Страница: 55 / 64

INSTRUKCJ A MONTAŻU I OBSŁUGI – SERIA LEO wersja 1.0
55
FINAL STEPS
5 5.1 Make sure the fireplace is cool.
Place the inspection element in the base of the burner.
Place the elements decorative in the combustion chamber.
Check that the decorative elements are not in contact with the glass.
Check that the control burner is not obstructed by decorative elements.
Replace the seal between the glass and the body of the device.
Mount the front window and wipe the outside of it.
Perform firing up and shutting down the device several times, checking the
correct operation of individual automation components.
Battery replacement
Used batteries in the receiver, remote control or power supply module may overheat,
spill or even explode. Do not install batteries into the device that have been exposed
to the sun, moisture, high temperatures or shocks. Only batteries of the same type and
manufacturer should be installed. Do not install new and used batteries. The remote
control is powered by two AAA batteries. The B6R-R8U receiver and the optional G60-
ZB90 power module are powered by four 1.5V AA batteries. The battery life of the
remote control and the receiver is estimated at about 1 heating season. The
manufacturer of the device recommends the use of alkaline batteries due to the lower
risk of their sealing. The use of rechargeable batteries is also permitted. When
removing the battery, do not use tools that can cause a short circuit. Replacing the
battery with electrically conductive objects can permanently damage the electronic
components of the remote control and the receiver. Batteries are classified as
hazardous chemical waste, so after use, they should not be disposed of with other
household waste.
Battery replacing in the remote control:
➢ Remove the cover on the back of the remote control.
➢ Gently remove the used AAA battery from the remote control.
➢
Install new AAA batteries, observing the polarity (+/-).
➢ Replace the cover on the back of the remote control
Replacing the battery in the receiver / power module:
➢ Open the control cabinet door.
➢ Carefully remove the B6R-R8U receiver / power module G60-ZB90.
➢ Remove the cover.
➢ Remove four used AA batteries and install new ones paying attention to the
polarity markings (+/-) on the receiver / power module housing.
➢
Replace the cover on the receiver / power supply module housing.