Kratki LEO Series, Инструкция по установке и эксплуатации

Страница: 35 / 64

INSTRUKCJ A MONTAŻU I OBSŁUGI – SERIA LEO wersja 1.0
35
Attention!!!
The pressure regulator is blocked by tightening its adjusting screw to its
maximum
Adjusting the minimum height of the main burner flame
1. Turn the main valve knob to the "OFF" position. Then turn them clockwise until the
valve opens.
2. The minimum flame height of the main burner can also be adjusted by tightening
the adjusting screw (Fig. 22).
3. Turn the screw clockwise to reduce the minimum flame height.
4. The minimum height of the main burner flame is factory set by the manufacturer.
Fig. 22. Method of adjusting the minimum height of the main burner flame
Checking for leaks
After connecting the system to the gas network, it is necessary to check the tightness
of the connections made using a special sensor. In the event of leaks, close the gas
shut-off valve and perform the installation of individual parts of the kit again.
Power connection
Attention!!!
Connect the power supply only after connecting the combustion air system and
all elements of the gas control system
The B6R-R8U receiver is powered by four 1.5V AA batteries. Special attention should
be paid so that the electric cables connecting the gas controller with the receiver are
kept away from hot elements of the fireplace. The indicator in the upper right corner of
the display indicates the need to replace the remote control battery, while short signals
appearing cyclically for three seconds immediately after starting the ignition procedure
in the fireplace indicate the need to replace the battery in the receiver. Used batteries