remote Control Operating Instructions:
The hand held remote control unit operates within a range of 7 metres (23ft) from the receiver located inside the main unit.
Any obstruction between the receiver and hand held remote may cause signal interference, limiting the ability to program
the main unit. Each time a remote control button is pressed, a beep will sound indicating a command (signal) is transmitted
and received on the main unit. When the command is received, the appropriate function will be displayed (temporarily)
in the LED display window and the green indicator light corresponding to the selection mode will illuminate the
main control panel.
Notes:
The LED display will default to show the ambient room temperature within 10 seconds of all program commands
POWer:
To turn the (air conditioner) power on/off, aim the remote control at the receiver (window) on the main unit and press the
“POWER” button.
MODe:
Press the “MODE” button to select “COOLING”, “FAN” or “DRY” mode (only in Cooling models).
seT COOLING / AUTO TeMPerATUre:
Press the “TEMP” (up / down) buttons to select (increase / decrease) the required operating temperature, the selected
temperature will appear (temporarily) in the LED display. The temperature settings are adjustable between 16
O
C to 31
O
C.
FAN:
Press the “FAN” button to select the required operating fan speed (HIGH, MED or LOW).
sWING:
Press the “SWING” button to activate the swing feature (the vertical louvres will oscillate automatically from side to side).
Press the “SWING” button again to deactivate the “SWING” feature.
TIMer:
Press the “TIMER” button to activate the “auto start/auto stop” timer function. Auto start/stop programs can be set from
0-12 hours. Each depression of the “TIMER” button will increase the selected time in 1 hour increments.
sLeeP:
In the Cooling mode, the cooling temperature set point will increase 1
O
C per hour after the “SLEEP” mode is selected. Two
hours later, the set point will continue at this temperature and the fan motor remain on LOW speed. Two hours later, the
set point will continue at this temperature and the fan motor remain on LOW speed. Using the “SLEEP” mode will reduce
noise creating a comfortable sleeping environment.
!
!
CAUTION
NeVer operate the air conditioner without the
air filter, as dust/dirt particles can contribute to
equipment failure.
11