To adjust vertical air flow direction, adjust any one of the
horizontal louver blades. When adjusting the horizontal
louver blades up or down, always keep the top or bottom
blades horizontal. This can effectively prevent water droplets
condensing on the front panel of the unit.
Vertical air flow adjustment (manually)
Air Filter
The air filter behind the inlet grill should be checked and
cleaned at least once every 2 weeks (or as necessary) to
maintain optimal performance of the air conditioner.
How to remove the air filter
1. Hold the slot under the front panel, then lift it
outwards, and remove the front panel.
2. Pinch the handle under the air filter and make the air
filter arched, remove it from the slot from underside to
upside.
3. Clean the filter with warm, soapy water. The water
should be below 40ºC to prevent distortion of the
filter.
4. Rinse off and gently shake off excess water from the
filter. Allow the filter to dry before replacing it. To prevent
distortion of the filter, do not dry in direct sunlight.
Drainage
To meet different requirement of different type of air
conditioner, there are two kinds of methods for your
choice to treat the condensed water.
For Cooling Only Models:
You can choose back drainage or non-drainage. See the
following procedures to perform back drainage:
1. Fit the seal onto the drain joint (which provided with
your air conditioner accessory).
2. Remove the rubber plug from the back of the unit.
3. Attach the drain joint to the back of the cabinet
where you remove the plug and rotate 90 to securely
assemble them.
4. Connect the drain joint with a extension drain hose
(Locally purchased)
SEAL
DRAIN
JOINT
RUBBER
PLUG
12
