Kontron AM4100, Руководство пользователя

Страница: 86 / 150

Configuration AM4100
Page 4 - 22 ID 36126, Rev. 2.0
P R E L I M I N A R Y
4.6.17 Delay Timer Control and Status Register
The delay timer enables the user to realize short, reliable delay times. It runs by default and
does not start again on its own. It can be restarted at anytime by writing anything other than a
’0’ to the delay timer control/status register. The hardware delay timer provides a set of outputs
for defined elapsed time periods. The timer outputs reflected in the Delay Timer Control and
Status Register are set consecutively and remain set until the next restart is triggered again.
Since the timer width and thus the availability of outputs varies over different implementations,
it is necessary to be able to determine the timer capability. Therefore, writing a ’0’ to the Delay
Timer Control and Status Register followed by reading indicates the timer capability (not the
timer outputs). For example, writing 0x00 and then reading 0xFF results in a 8-bit wide timer
register. This status register mode can be switched to normal timer operation by writing any-
thing other than a ’0’ to this register.
Table 4-26: Delay Timer Control and Status Register
REGISTER NAME DELAY TIMER CONTROL / STATUS REGISTER
ADDRESS 0xEC00_028F
BIT NAME DESCRIPTION
RESET
VALUE
ACCESS
7-0 DTC Delay Timer Control
The hardware delay timer is operated via one simple 8-bit control/
status register. During normal operation, each of the 8 bits reflects a
timer output which means defined elapsed time period after the last
restart according to the following bit mapping:
DTC[7:0] Value
Bit 7:
1 ms
Bit 6: 500 µs
Bit 5: 250 µs
Bit 4: 100 µs
Bit 3: 50 µs
Bit 2: 10 µs
Bit 1: 5 µs
Bit 0: 1 µs
0x00 R/W