Konica Minolta 7020, Инструкция по эксплуатации

Страница: 220 / 266

12-6
[2] Copier Initial
Initial settings are the settings that display automatically when the copier is powered
on, when Auto Reset timer is operated, or when
AUTO RESET
is pressed.
These settings can be changed by the key operator, as shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition to meet
Energy Star requirements:
Initial Setting
Copy Mode: 1-1
Copy Density: AE
Lens Mode: 1:1
Paper Tray: APS
Output Mode: Offset sort
When Initial settings are changed by the key operator, the new initial settings display
when the copier is powered on, when Auto Reset timer is reached, or when
AUTO RESET
is
pressed.
NOTE:
When changing “Initial” to “Full-Auto” in the Memory switch No.2, you cannot use the new initial
settings. See p. 12-35.
The following initial settings can be changed by the key operator:
Copy mode: [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density: [AE; manual]
Lens mode: [AMS; 1.00; ratio 0.25~4.00]
Paper tray: [APS; trays 1, 2, 3, 4, or Multi-sheet bypass tray]
Output mode: [Tray 1, 2, 3, 4; Sort, Group, Staple; Rotation On/Off; Staple
location] (machine with Finisher)
[Tray 1, 2; Group, E-SORT+sort, E-SORT+group; Rotation
On/Off] (machine with Inner tray)
[Group, E-SORT+sort, E-SORT+group; Rotation On/Off]
(machine without Finisher)
Non-image erase: [Oblique erase, Rectangular erase; Original density]
Setting procedures are described on the following pages.
NOTE:
The most commonly-used settings are established at installation. Before changing any of the
copier settings, be sure that you understand the overall and long-range effect of the change.