Kongsberg EM 710, Руководство по установке

Страница: 56 / 155

Kongsberg EM 710
6.2.5 Surface preservation
All metal surfaces which are likely to corrode should be painted.
This includes welds, base frames and support brackets. Make
appropriate cautions to avoid spilling of paint on the cabinet
6.3 Remote Control Junction Box
This chapter presents the general installation procedures for the
Remote Control Junction Box.
The Junction Box is a steel cabinet. The front door opens towards
left, while the cables enter through the bottom of the cabinet.
6.3.1 Location
The Remote Control Junction Box will normally be located in
the vicinity of the Operator Station. It holds the interconnection
between the various units in the EM 710 system, and may also
contain the master on/off switch for the entire system.
6.3.2 General information
The Remote Control Junction Box cabinet’s total height is 300
mm.
Junction Box – outline dimensions on page 132
6.3.3 Logistics
Safety - Refer to the general safety procedures.
Personnel - Trained mechanical/electrical workers
Ship location - No recommendations. The watertight integrity of
the ship will not be affected.
Special tools - None
References - None
Drawings
- Refer to the Drawing file
How to install the Cabinet
Caution
Always ascertain what is on the other side of bulkheads
and decks before drilling or welding.
1
Drill the required holes in the selected bulkhead, each hole
capable of taking an M8 bolt. The bolts are included with
the cabinet.
2
When the preparations for the bolts have been completed,
position the cabinet and mount and tighten the securing
bolts.
3 Use shake-proof washers, and tighten the bolts to a torque of
approximately 50 Nm.
54
164851/C