Komatsu D65EXi-18, Руководство по эксплуатации и техническому обслуживанию

Страница: 80 / 184

Select “Cutting & Carry” or “Simple Grading”.
(T) Design surface
REMARK
If the steering operation is needed to recover from the sideways slip of machine while traveling on the side slope
parallel to the slope, avoid the sideways slip according the following procedure.
• Decrease the load against the blade.
It is recommended to set the dozing depth to 10 to 20 mm when finishing a slope surface by operating hori-
zontally.
• Decrease the travel speed.
It is recommended to set the gear speed to the 1st when traveling on a slope horizontally.
• Do not drive the machine parallel to the slope, but drive it diagonally.
WHEN FINISHING CONCAVE INFLECTION POINT VERTICALLY
This is the operation to finish the bank by crossing over the place where the angle of design surface changes
sharply.
Select “Simple Grading”.
REMARK
When “Simple Grading” is selected, you cannot set the Smooth
Start and the blade load mode.
At the place where the angle of design surface changes sharply, operate the decelerator pedal to decrease the
travel speed.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-66