Komatsu D65EXi-18, Руководство по эксплуатации и техническому обслуживанию

Страница: 62 / 184

The present mode selection is displayed.
The mode which has a check mark on the left is selected.
“Smooth Start” is enabled with a check mark on the left
and disabled without a check mark.
3.
Press “Smooth Start” to select enable or disable.
REMARK
With the same procedure, dozing mode and blade load mode can be set.
FUNCTION RELATED WITH MACHINE MONITOR BLADE AUTOMATIC CONTROL
The following descriptions give you the functions related to automatic control of blade among the functions of
the machine monitor.
For other functions of the machine monitor and handling method, see the Operation and Maintenance Manual of
standard machine.
ADJUST GAIN OF AUTOMATIC BLADE CONTROL
If the response speed of lift RAISE/LOWER and tilt RIGHT/LEFT during the blade automatic control is too fast
or too slow, the ground may become waved or undulate after the leveling work.
At this time, the gain of lifting and tilting can be adjusted with the user menu of the machine monitor.
The gain means the setting which decides the response speed of blade while it is automatically controlled. Se-
lect “Default” or “Option A” to set it.
Select “Default” for the leveling work or dozing work on general soil.
Select “Option A” if leveled ground becomes waved or undulate under the selection of “Default” and the gain of
lift RAISE/LOWER or tilt RIGHT/LEFT should be adjusted individually.
METHOD FOR ADJUSTING GAIN OF AUTOMATIC BLADE CONTROL
1.
Press switch F6 on the standard screen of the machine
monitor to display the user menu.
F6: User menu display switch
2.
Press switches F1 and F2 and move the menu to right and
left to display “Machine Setting” screen (1).
The current gain setting is displayed on “Blade Auto Con-
trol Gain Adjustment” (2).
On this screen, it is possible to perform the following oper-
ations with switches F1 to F6.
F1: Moves to the left menu. When on the left end, it moves
to the right end menu.
F2: Moves to the right menu. When on the right end, it
moves to the left end menu.
F3: Moves to the next item (1 line below). When on the last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When on the first line, it moves to the last line.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-48