Koike Sanso Kogyo IK-12 NEXT, Руководство по эксплуатации

Страница: 44 / 60

IK-12 NEXT
- 40 -
5.9.2 In bevel cutting
In case of bevel cutting, tilt torch to the desired angle. Depending on the combination of tip, it is
possible to cut as shown in the figure.
5.9.3 In circle cutting
The machine is set up differently in two configurations as shown in the photograph to
the left. Set up for circle cutting is as follows.
■ For circle cutting attachment
1. Remove the shield plate, and free the idle wheel
by removing the fixing washer
.
2. Attach pivot pin and weight to radius bar. Please attach
weight as close to the center as possible.
3. Free the guide wheel and pull the machine so that
it describes a natural arc, and tighten the guide
wheel in its natural position.
4.
Cutting capacity φ600
～
φ2200
■
For circle rail
1. Align the idle wheel to the inside groove of the
track, and the guide wheel to the outside groove.
2. Free the guide wheel and tighten it in its natural
position.
3. Cutting performance may be improved by forward
travelling.
4. Cutting capacity
φ100
～
φ360 φ770
～
φ1150
V bevel cutting
Y bevel cutting
X bevel cutting
Welding
Welding
Welding
Bar
Weight
Circle cutting
arm assembly