17
1493953-W2-A
New Installation
While planning your shower installation, make sure you allow sufficient clearance
between the ceiling and walls to allow any future maintenance (cleaning the filter
etc.) to be performed.
Using the installation template
supplied, mark the positions
of the
three
fixing holes.
Note!
Ensure that there are
sufficient lengths of supply pipe
and electrical cable to reach the
connection points as shown on
the template.
Place Spirit Level on This Line to
Level Product Before Drilling
Allow at least 200mm
above the appliance to
access cover screws.
See Installation Guide
for further dimensions
especially for a shower
replacement.
Installation
Template &
Checklist
1180328-W7-A
© Kohler Mira Limited, July 2011
Place Spirit Level on This Line to
Level Product Before Drilling
Installation
Template &
Checklist
Mira Sport NG Thermostatic
Attention Installer
IMPORTANT! The following key details should be read
in conjunction with the Installation and User Guide.
Do not install the appliance where
it may become frozen.
Avoid dust contamination of the
appliance by using this template
to mark and drill into the wall. Drill
appliance case separately.
Do not use alternative screws to
secure the cover.
Do not seal any part of the
appliance.
Thoroughly flush the pipework
before connecting to the appliance.
Use the correct
supply cable size.
Refer to BS 7671.
Do not drill into buried cables or
pipes.
1180327-W7-A
© Kohler Mira Limited, July 2011
Mira Sport Multi-fit
Attention Installer
Do not install the appliance where
it may become frozen.
Avoid dust contamination of the
appliance by using this template
to mark and drill into the wall. Drill
appliance case separately.
Do not drill into buried cables or
pipes.
Do not use alternative screws to
secure the cover.
Do not seal any part of the
appliance.
Thoroughly flush the pipework
before connecting to the appliance.
Use the correct
supply cable size.
Refer to BS 7671.
Fixing
Hole(s)
LOWHIGH
ECO
POWER
TEMPERATURE
LOWHIGH
ECO
POWER
TEMPERATURE
Fixing
Hole(s)
Outlet Connector
Fixing
Hole(s)
Rear water
entry point with
Inlet Connector
(RH) rotated to
position A
Inlet
Connector (LH)
IMPORTANT! The following key details should be read
in conjunction with the Installation Guide.
Rear water
entry point with
Inlet Connector
(RH) rotated to
position B
Position B
Position A
Inlet Connector (RH)
1
2
3
Remove the installation template
and drill the fixing holes. Insert
the wall plugs (supplied).
Caution!
Do not drill into buried
pipes or cables.
Remove the cover and service
tunnels from the Mira Sport Multi-
fit. Keep the retaining screws (x3)
for later use.
Snap Off section
of Upper Case
Insert shown.
Note!
Greyed out
sections can be
removed to suit
installation.
4
Adjust for RH water supply
and / or RH electricity supply
if required, see sections
"
Adjustment for right hand
entry water supplies"
and
"
Adjustment for right hand
electrical supplies".
