Kohler COMMAND CH18, Руководство по обслуживанию

Страница: 205 / 232

11.7
Section 11
Reassembly
11
Figure 11-19. Closure Plate Sealant Pattern.
4. Make sure the end of the governor cross shaft is
lying against the bottom of cylinder 1 inside the
crankcase. See Figure 11-13.
5. Install the closure plate to the crankcase.
Carefully seat the camshaft and the crankshaft
into their mating bearings. Rotate the crankshaft
slightly to help engage the oil pump and
governor gear meshes. See Figure 11-20.
Figure 11-22. Torquing Closure Plate Fasteners.
Install Stator and Backing Plates
1. Apply pipe sealant with Teflon
®
(Loctite
®
No
59241 or equivalent) to the stator mounting holes.
2. Position the stator aligning the mounting holes so
that the leads are at the bottom, towards the
crankcase.
3. Install and torque the two hex flange screws to
6.2 N·m (55 in. lb.)
. See Figure 11-23.
3. Apply a 1.5 mm (1/16 in.) bead of sealant to the
sealing surface of the closure plate. See Figure
11-19 for sealant pattern.
Figure 11-20. Using Spanner Wrench to Turn
Crankshaft.
1
10
8
6
4
2
9
7
5
3
6. Install the ten hex flange screws securing the
closure plate to the crankcase. Torque fasteners in
the sequence shown in Figure 11-21 to
24.4 N·m
(216 in. lb.) . On some engines one of the ten
mounting screws is plated. The plated screw is
typically installed in the #6 hole shown in Figure
11-21.
Figure 11-21. Closure Plate Fastener Torque
Sequence.