6.3
Section 6
Lubrication System
6
1. Clean the areas around the drain plug, oil filter,
oil fill cap and dipstick.
2. Remove one of the oil drain plugs. A drain plug is
located on either side of the crankcase; one is
adjacent to and below the oil filter, the other is
below the starter.
3. Allow all oil to drain and then reinstall the drain
plug. Torque to
13.6 N·m (10 ft. lb.)
.
4. Remove the old filter and wipe off the filter
adapter with a clean cloth.
5. Place a new replacement filter in a shallow pan
with the open end up. Pour new oil, of the proper
type, in through the threaded center hole. Stop
pouring when the oil reaches the bottom of the
threads. Allow a minute or two for the oil to be
absorbed by the filter material.
6. Apply a thin film of clean oil to the rubber gasket
on the new filter.
7. Install the new oil filter to the filter adapter.
Hand tighten the filter clockwise until the rubber
gasket contacts the adapter, then tighten the
filter an additional
3/4-1 turn
.
8. Remove the oil fill cap and fill the engine with the
proper oil to the ‘‘F’’ mark on the dipstick.
Always check the oil level with the dipstick
before adding more oil.
9. Reinstall the oil fill cap and dipstick.
10. Start the engine and check for oil leaks. Stop the
engine, correct any leaks, and allow a minute for
the oil to drain down, then recheck the level on
the dipstick.
Figure 6-5. Removing Oil Fill Cap.
5. Reinstall the oil fill cap.
Changing Oil Filter
Replace the oil filter
at least every other oil change
(every 200 hours of operation)
. Always use a genuine
Kohler oil filter. Change the filter as follows. See
Figure 6-6.
Figure 6-6. Oil Drain Plug and Oil Filter (Engine
With Oil Cooler).
Oil Filter
Oil Cooler
Oil Drain Plug
3. Allow all the oil to drain and then reinstall the
drain plug. Torque to
13.6 N·m (10 ft. lb.)
.
4. Remove the oil fill cap and fill the engine with the
proper oil to the ‘‘F’’ mark on the dipstick.
Always check the oil level with the dipstick
before adding more oil.
Содержание COMMAND CH18
Страница 1: ...SERVICE MANUAL HORIZONTAL CRANKSHAFT COMMAND CH18 750...
Страница 98: ......
Страница 99: ......
Страница 102: ......