Kohler COMMAND CH18, Руководство по обслуживанию

Страница: 116 / 232

6.2
Section 6
Lubrication System
NOTE: To prevent extensive engine wear or damage,
always maintain the proper oil level in the
crankcase. Never operate the engine with the
oil level below the ‘‘L” mark or above the ‘‘F”
mark on the dipstick.
Changing Oil and Oil Filter
Changing Oil
Change the oil after every 100 hours of operation
(more frequently under severe conditions). Refill with
service class SG, SH, SJ or higher oil as specified in the
“Viscosity Grades” table on page 6.1.
Change the oil while the engine is still warm. The oil
will flow more freely and carry away more
impurities. Make sure the engine is level when filling
or checking oil.
Change the oil as follows:
1. Clean the areas around one of the oil drain plugs,
oil fill cap, and dipstick.
2. Remove one of the oil drain plugs. A drain plug is
located on either side of the crankcase; one is
adjacent to and below the oil filter, the other is
below the starter. See Figure 6-4.
Figure 6-4. Location of Oil Drains.
Checking Oil Level
The importance of checking and maintaining the
proper oil level in the crankcase cannot be
overemphasized. Check oil
BEFORE EACH USE as
follows:
1. Make sure the engine is stopped, level and is cool
so the oil has had time to drain into the sump.
2. Clean the area around the dipstick before
removing it. This will help to keep dirt, grass
clippings, etc., out of the engine.
3. Remove the dipstick; wipe oil off. Reinsert the
dipstick into the tube until fully seated. See
Figure 6-2.
Figure 6-3. Oil Level Marks on Dipstick.
Oil Drain Plug Starter Side
Oil Drain Plug Oil Filter Side
Dipstick
Oil Fill Cap (Valve
Cover Location)
Operating
Range
Figure 6-2. Location of Oil Fill Cap and Dipstick.
4. Remove dipstick and check oil level. The level
should be between the ‘‘F’’ and ‘‘L’’ marks. If low,
add oil of the proper type up to the "F" mark.
Reinstall oil fill cap and dipstick.