OPERATING MANUAL HPC & UMC4
Page 83 of 105
14.11.3 Measured value simulation
If the operator selected the setting “QM, D, T” described in Section 14.11.2 on page 82, the following
three possible settings will affect the output behavior during measured value simulation, where all meas-
ured values are simulated at the same time.
14.11.3.1 Simulation mass flow QM abs
In order to simulate mass flow, the operator can define a “measured value.” The flow rates will be simu-
lated in both directions. All outputs will perform based on the simulated measured value.
Set QM abs
±0900.0 kg/h
The simulation value is entered as described in Section 13.4.3.2 Input window/modify a value.
14.11.3.2 Density simulation
In order to simulate density/vo
lume measurement, the operator can define a “density measured value.” If
volume measurement is assigned to an output, it will change depending on mass flow and density simula-
tion. All outputs will perform based on the simulated measured value.
Set density
0500.0 g/l
The simulation value is entered as described in Section 13.4.3.2 Input window/modify a value.
14.11.3.3 Temperature measurement simulation
In order to simulate a temperature, the operator can de
fine a “measured value.” All outputs will perform
based on the simulated measured value.
Set temperature
+090 °C
The simulation value is entered as described in Section 13.4.3.2 Input window/modify a value.
