KNF N630 EX, Перевод оригинальной инструкции по эксплуатации и установке

Страница: 46 / 144

Servicing Diaphragm pump N630 EX
46 Translation of Original Operation and Installation Instruction, english, KNF 320945 04/21
Checking the sprocket
Observe the intervals for the periodic inspection of the coupling play
(see operating instructions for the coupling).
1. Place the sprocket (4) on the motor-side coupling half (5).
2. Place the test adapter for the coupling on the motor-side coupling half (5).
3. Use the feeler gauge to check the coupling play (see operating instruc-
tions for the coupling).
4. Replace the sprocket (4) if there is too much coupling play (see operating
instructions for the motor).
5. Define the intervals for the periodic inspection of the coupling play (see
operating instructions for the motor).
Replacing the sprocket
1. Remove the worn sprocket (4) from the motor-side (5) or pump-side cou-
pling half (6).
2. Push the new sprocket (4) onto the pump-side coupling half (6).
The sprocket is symmetric and can be pushed on in both possible po-
sitions.
Mounting the motor
1. Align the motor-side (5) and pump-side coupling halves (6) with one an-
other.
2. Place the motor (3) on the compressor housing (7).
Centering is performed using the four stud bolts (8) in the flange of the
compressor housing (7) as well as the previously inserted sprocket.
3. Check whether the flange surface of the motor (3) and the flange surface
of the compressor housing (7) lie properly on top of one another.
4. Push the 4 serrated washers (2) onto the stud bolts (8).
Make certain that the inner diameter of the serrated washer (2) lies
against the nut (1) and the outer diameter lies against the motor flange
(3).
5. Turn the 4 nuts (1) on the stud bolts (8) and tighten them crosswise (tight-
ening torque: 11 Nm).
Inspecting pumps
1. Loosen the fastening screws (10) of the motor fan cover (9) and remove
the motor fan cover (9).
2. Check the pump for smooth running by turning the fan wheel.
3. Remount the motor fan cover (9).
4. Again hand-tighten the fastening screws (10).