KNF N630 EX, Перевод оригинальной инструкции по эксплуатации и установке

Страница: 103 / 144

Electric motors Size 63 - 225 ATEX / IECEx
Faults
46
2016-05-23
Fault Possible cause Remedy To be
remedied by
Bearing noises Scoring on inner bearing
ring, e.g. from motor
starting up with bearing
locked Replace bearing, avoid
vibrations when at a
standstill Manufacturer
Motor is not running
smoothly
Imbalance due to belt
pulley or coupling
Balance exactly Manufacturer
Machine fastening
insufficient Check machine fastening Qualified
specialist
Motor does not start up
Considerable drop in speed
Load moment too high Check motor torque and
load moment Qualified
electrician
Supply voltage too low
Check power supply
conditions Qualified
electrician
Motor does not start up
Considerable drop in speed
Safety device is triggered
Phase interrupted Check the mains
connection Qualified
electrician
Motor does not start up
Motor is too warm
Considerable drop in speed
Safety device is triggered
Incorrect circuit Adhere to wiring diagram
and type plate Qualified
electrician
Motor is too warm
Considerable drop in speed
Safety device is triggered
Overload
Adhere to stipulations on
type plate Qualified
electrician
Motor is too warm
Safety device is triggered
Too many switching
actuations Observe rated operating
mode Qualified
electrician
Motor is too warm Ventilation insufficient Check cooling air routes,
check direction of rotation Qualified
electrician
Ventilation ducts soiled Clean the ventilation ducts Qualified
specialist
Safety device is triggered Coil or terminal short
circuit Measure the insulation
resistance Qualified
electrician
The start-up time has been
exceeded Check the start-up
conditions Qualified
electrician
Pos : 8. 20 /KN 2006-SM /nL---------- Abschnitts ende ---------- @ 8\ mod_1141997892953_0.doc @ 75471