Knauer Azura P 2.1L, Руководство пользователя

Страница: 21 / 44

P 2.1L user manual V6840, version 3.6
18 Installation
Next steps Check if the cables are firmly attached. Push the terminal strip onto the
multi-pin connector. Finish the installation. Put the device into operation.
Computer Control
Computer control means to operate the device within a local network
through a router. The connector is located on the rear side
.
Note: HPLC devices made by KNAUER work only with IP adresses which
are assigned via IPv4. IPv6 is not supported.
This section describes how to set up an HPLC system in a local area net-
work (LAN) and how a network administrator can integrate this LAN into
your company network. The description applies to the operating system
Windows and all conventional routers.
To set up a LAN, we recommend to use a router. That means the following
steps are required:
Process 1. On the computer, go to the control panel and check the LAN proper-
ties.
2. Hook up the router to the devices and the computer.
3. On the computer, configure the router to set up the network.
4. Install the chromatography software from the data storage device.
5. Switch on the device and run the chromatography software.
Configuring the LAN settings
The LAN uses only one server (which is normally the router) from that the
devices automatically receive their IP address.
Prerequisites

In Windows, power saving, hibernation, standby, and screen saver
must be deactived.

In case you use an USB-to-COM box, the option "Allow the computer to
turn off ths device to save power" in the devicemanager must be deac-
tivated for all USB hosts.

For all LAN devices: For the network adapter, the following option in
the Device Manager must be deactivated: "Allow the computer to turn
off this device to save power".
Process 1. In Windows open the
Network and Sharing Center
.
2. Double-click on
LAN Connection
.
3. Click on the button
Properties
.
4. Select
Internet Protocol version 4 (TCP/IPv4)
.
Legend
1
LAN port
Fig. 27 P 2.1L rear view
2