Kingsley KIP-20, Руководство по эксплуатации и обслуживанию

Страница: 8 / 42

8
6. Install plastic disc and secure the assembly with the washer, spring, and clamp collar.
The foil must thread under the “Foil Out” lever or the wire-marking machine will not
operate.
7. Feed a scrap piece of paper or thin object from the front of the machine toward the back
and under the ““Foil Out" lever just in front of the spool of foil.
8. Tape the end of the foil to the scrap of paper and pull the foil to the front of the machine.
9. Refer to Figure 4 and thread the foil between the knurled rollers. Manually turn the knurled
rollers with feed knob to advance the foil through the knurled rollers. Ensure that the
foil is feeding straight and that it is centered to the typewheels.
Figure 4 Loading Foil into Feed Mechanism
SELECT AND INSTALLING THE WIRE FIXTURE
Kingsley offers a complete range of wire holding fixture sizes (refer to Appendix B). Figure
5 illustrates the wire fixtures and calls out the important elements: Wire Guide and Wire
Groove.
Note : It is possible to inadvertently use a wire fixture that is too large for a
wire, for example using a 0.076 inch (19.3 mm) fixture for 0.072 inch (18.29
mm) outside diameter wire. The wire will not seat correctly and may move
laterally in the close tolerance groove during the marking process. Wire
marking will be inconsistent. The type may also cut or nick the insulation.