Kingsley KIP-20, Руководство по эксплуатации и обслуживанию

Страница: 9 / 42

9
It is also possible to use a wire fixture that is too small for a wire since guides are oversize by
0.010 inch (0.254 mm). During the marking phrase, the type will drive the larger diameter wire
into the small radius wire groove. Depending on the insulation material, the wire may become
tightly wedged in the groove making it difficult for the host machine to advance the wire for the
next mark.
Use the following procedure to mount the wire fixture.
1. Orient the fixture so that the test hole and mounting dimples face the front
of the machine.
2. Insert the fixture from the left side of the machine and slide it into the
master fixture. Pus the fixture to the right until it hits the stop pin.
3. Secure the fixture by tightening the two locking setscrews until they are
snug.
Figure 5 Wire Fixture
SETTING THE LEGEND
If Typewheel were ordered with the KIP-20, they were mounted at the factory, and the unit is ready
to operate. If Typewheel were ordered separately, they must be installed before the KIP-20 is
ready to operate. Refer to
INSTALLING TYPEWHEELS in the MAINTENANCE Section of this
manual to install or change typewheels.
Use the following procedure to set the typewheels for the correct legend.
1. Refer to Figure 6 and disengage the typewheel lock bar by swinging the lever out. The lever
unlocks the typewheels and opens the type lock micro switch preventing the machine from
stamping.
NOTE: It may be necessary to rotate the knob on the selector slightly to allow the selector to
slide past the typewheels.