Kingsley KIP-20, Руководство по эксплуатации и обслуживанию

Страница: 6 / 42

6
POWER CONNECTION
Never use an ungrounded electrical power source. Using an ungrounded
or improperly grounded source can result in a risk of electric shock and
serious injury or death.
The use of non-dedicate AC electrical service to the wire-marking
machine may result in improper operation and damage to the equipment.
The KIP-20 requires 4 Amp. 115 VAC (3 Amp 230 VAC optional) of available incoming
power. Ensure that the available power is sufficient for the system and that electrical
equipment and installation meets all national and local codes.
Ensure that the ON/OFF switch is in the OFF position, and plug the power cord into the
properly ground power source.
AIR CONNECTION
The use of non-filtered or unregulated compressed air supply may
result in improper operation and damage to the equipment. The KIP-
20 ships with a filter and regulator assembly that must be used.
Endure that the supply source is capable of maintaining a constant air
pressure of 100 psi.
The air cylinder and the control valve are pre-lubricated. The KIP-20 requires a filtered
unlubricated and regulated 100 psi. air source to ensure that the air supply meets the
requirements of the machine.
High-pressure compressed air used in the imprinter can cause
serious injury to eyes and other sensitive tissue. Always wear
safety glasses when working with compressed air. Being hit by
runaway hoses can result in serious injury. Never try to grab a
runaway hose. Immediately shut off air supply if a hose or fitting
breaks. Shield yourself from broken compressed air lines or
fittings.
Use the following procedure to connect the air supply to the wire-marking machine. Use
suitable sealant on the threads of all the fittings on the air lines.
1. Bring the ¼” airline to the input side of the filter/regulator.
2. Attach the air line and tighten the fittings.
3. Dress the airline to ensure that there are no kinks and that it is protected from any
moving parts.
4. Open the supply valve to apply air to the imprinter.
5. Check for air leaks and tighten fitting if necessary.