Kingsley KIP-20, Руководство по эксплуатации и обслуживанию

Страница: 22 / 42

22
18. If the typewheels are not centered to the mandrel, loosen the left
spacer and slide the typewheels and spacers to the approximate
center. Secure the left spacer by tightening the setscrew until it is
snug.
NOTE: The typewheels must be free to turn when they are
assembled to the mandrel. As the typewheel heat, they become
snugger.
Figure 12 Installing Typewheel(s)
19. Allow approximately 0.03 inch (0.75 mm) overall gap in the
typewheels, and snug the setscrew to secure.
20. Align the typewheels to each other and re-engage the typewheel lock
bar by swinging the lever in. The lever locks the typewheels in place.
21. Place the type selector assembly onto the marking machine.
Exercise caution when securing the type selector assembly. Over-
tightening the securing screw or tightening them unequally can
damage the assembly.
22. Reinstall and finger tighten the four securing screws. Ensure that the
screws have threaded evenly and then tighten them one at a time.
23.
Release the typewheel lock bar and make sure that the typewheels
rotate on the mandrel.
24. Set the typewheels for the correct legend and re-engage the
typewheel lock bar.
25. Plug the power cord back into the power receptacle and turn on the
compressed air supply.