Kimo Kigaz 300 CLA, Руководство пользователя

Страница: 36 / 52

Sensors have very accurate locations, see below locations defined for each sensor :
•
O
2
sensor must be in O
2
position
•
CO
sensor must be in
CO position
•
CO sensor must be in position 3
•
NO
2
, SO
2
and CH
4
sensors must be in position 4.
* : NO
2
, SO
2
and CH
4
sensors
When a sensor has been replaced, it is possible to check the proper functioning of this new sensor by going
in the
“Information” menu of the analyser. It is normal that a sensor that has just been installed gives the
following message : “Current Error” , it is necessary to wait a few time to stabilize the polarization of the sensor.
Here are the stabilization times for each sensor :
•
O
2
: 48 hours
•
CO-H
2
: 48 hours
•
NO : 48 hours
•
NO
2
: 48 hours
•
SO
2
: 48 hours
•
CH
4
: 48 hours
20.3. Replace the paper roll of the printer
Follow this procedure to replace the paper roll of the printer :
➢
Raise the upper part of the printer.
➢
Put the paper roll in the required location.
➢
Pull up slightly on the paper : it must be caught between the upper part and the lower part of the printer.
➢
Close the upper part.
Some paper must be out from the slot situated between the lower part and the upper part of the printer part.
Both sides of the paper are different : the brightest side is the printed side and must faced the user.
36
Maintenance of the analyser
Upper part to
raise
Paper location Introduction of
the paper roll
Paper correctly
introduced
Insertion of a new sensor then rotation
of the sensor
Connection of the
sensor ribbon cable
5 6
CO
O
2
Autres*
NO
netzerotools.com
netzerotools.com