Kilsen KFP-CE4 Series, Руководство по установке

Страница: 8 / 92

Chapter 1: Introduction
2 KFP-CE4 Series Installation Manual
Product range
Panels in the KFP-CE4 Series are conventional fire and evacuation control
panels. The series includes the models shown below.
Model Description
KFP-CE4 Four- zone conventional fire alarm and evacuation control panel, supporting four
evacuation areas without alarm counter
KFP-CE4-NL Four- zone conventional fire alarm and evacuation control panel, supporting four
evacuation areas with alarm counter
All models have been designed in accordance with EN 54- 2, EN 54- 4, and
NEN 2575 standards. For further details, see Appendix B “ Product compliance”
on page 81.
Product compatibility
Products compatible with this control panel are specified in the supplied
compatibility list. Compatibility with products that are not listed in that document
cannot be guaranteed.
For further details contact your local supplier.
Operating modes
Supported operating modes are shown in the table below. The default operating
mode is NEN 2575 with four evacuation areas.
Table 1: Operating modes
Operating mode
EN 54-13 option [1] Region
NEN 2575 4E (default) Available [2] European Union
NEN 2575 2E Available European Union
NEN 2575 1E Available European Union
[1] EN 54-13 supervision requires compatible system wiring and devices and must be enabled by
the installer in the control panel configuration.
[2] Requires a 2010 -1-SB expansion board to be installed (not supplied).
Two menu inserts are available to label the panel controls and indicators. In its
default configuration, the panel does not use EN 54 - 13 zone supervision, and the
corresponding insert has no Fault Output Fault/Disabled LED.