Kilsen KFP-CE4 Series, Руководство по установке

Страница: 61 / 92

Chapter 3: Configuration and commissioning
KFP-CE4 Series Installation Manual 55
• Polarity is observed for all sounder circuits and that all end-of-line resistors
are installed, as described in “ Connecting sounders or other notification
devices to supervised outputs” on page 17
• Any optional equipment inst alled (fire routing, alarm, and fault relays, etc.) is
correctly connected
• The batteries are connected correctly, and comply with all requirements
described in “ Connecting the batteries” on page 20
• All fire alarm and evacuation system configuration complies with the
corresponding operating mode and local regulations
Commissioning the control panel
Once all installation, connection, and configuratio n requirements have been
checked as described above, the control panel can be powered up.
Normal startup
After starting up the control panel, normal status (standby) is indicated as follows:
• The Supply LED is steady
• The Fire Routing Delay LED is steady (if a delay has been enabled)
If any other indicators are on, check your installation thoroughly before
proceeding.
Fault startup
In accordance with EN 54- 2, the control panel has a special startup sequence
used after an internal fault has been detected by the control panel.
This is indicated as follows:
• The General Fault LED flashes fast
• The System Fault LED flashes slow
When this happens:
1. Enter the Operator user level password.
2.
Press the Reset button to reset the control panel.
If the fault status persists after reset, the control panel aborts the startup
sequence and turns on the System Fault LED.
When this happens, check all control panel connections and configuration, as
described in “ Before commissioning the control panel” on page 54.
Battery startup
To power up the control panel from the batteries, press the battery start button on
the control panel PCB (marked as BAT. START, see Figure 19 on page 56 ).
Keep the button pressed for approximately 5 seconds.