Kilsen KFP-CE4 Series, Руководство по установке

Страница: 38 / 92

Chapter 3: Configuration and commissioning
32 KFP-CE4 Series Installation Manual
A selected list of operating mode configuration presets is shown below. For a
detailed list of all available configuration presets and characteristics, see
Appendix A “ Configuration presets” on page 71.
Table 19: Common operating mode configuration presets (EN 54-13 disabled)
Display
Operating mode Zone end-of-line Zone type
41 (default) 4E (four evacuation areas) Passive Odd zones: Automatic
Even zones: Manual
43 2E (two evacuation areas) Passive Odd zones: Automatic
Even zones: Manual
45 1E (one evacuation area) Passive Odd zones: Automatic
Even zones: Manual
The operating mode is indicated by the first digit in the display and the
configuration type by the second digit. If a custom configuration has been applied
(via the advanced configuration menu), then the second digit is a zero, as shown
below.
Display Configuration
41 NEN 2575 four evacuation areas preset configuration
43 NEN 2575 two evacuation areas preset configuration
45 NEN 2575 one evacuation area preset configuration
40 NEN 2575 custom configuration
EN 54-13 supervision mode
Use this menu to select the zone supervision mode (EN 54 -13 supervision
enabled or disabled). By default EN 54- 13 zone supervision is disabled.
To configure the supervision mode:
1. Set the display as shown below, and then press Enter.
The Sounder and Fire Routing Fault/Disable/Test LEDs and all zone LEDs
flash quickly to indicate that the supervision mode configuration menu is
active.
2. Select the supervision mode using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.