4-1
LaserNET Program User's Guide
September 2003
TM0048
CHAPTER 4
CONFIGURING THE IIM
4-1
INTRODUCTION
Follow the instructions in this chapter if either Local IIM or Remote IIM was specified in the System Configu-
ration screen as explained in Paragraph 3-2.
This chapter describes how to configure the IIM. Skip this chapter if a Direct Connection is used.
Note:
LaserNET will not allow IIM configuration unless the connection between the personal computer
and the IIM has been properly configured and specified in LaserNET. If the connection information
has not yet been entered in LaserNET, refer to Chapter 3 and follow the directions before
proceeding.
4-2
INTELLIGENT INTERFACE MODULE WINDOW
The IIM window displays the status of the IIM (Figure 4-1). To open the Intelligent Interface Module window,
select
IIM
from the upper right hand corner of the LaserNET main menu bar. The computer must be com-
municating with the IIM to access this window in either the Local or Remote mode. This screen is available
without entering a password. The Setup Menu is only available in Local IIM mode and requires an installer
password.
Figure 4-1. IIM Window
4-3
OWNER LOCATION INFORMATION
The IIM provides a means of identifying itself to the LaserNET software by programming into the IIM a
unique name called the owner location. To program the owner location:
1. Enter the installer password.
2. Select
IIM
from the main screen. The Intelligent Interface Module window opens, as shown in Figure
4-1.
3. Select
Setup>Owner Location
from the menu bar. The IIM Location window opens, as shown in
Figure 4-2.
Figure 4-2. IIM Location Window
Содержание HART XL
