6
Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
On-Module Mounted Cabinets
11. The mounting brackets have
integral teeth that engage in the
vertical furniture hanging slots in
the panel frame. Locate the
on-module cabinet at the height
that is desired on the panel. Engage
the antidislodgement tooth into the
panel frame by holding the cabinet
bottom out about 30°, then rotate
the cabinet bottom down to engage
all the remaining teeth. When all
teeth are engaged, press down on
the cabinet to lock in place
(Detail A).
Caution:
To remove the cabinet
assembly from the panel, push the
bottom of the cabinet straight up
about
1
/
4
” and rotate the bottom out
toward you to about 30°. Pull the
cabinet straight out and down. Do
not force the side panel, damage to
the top tooth may result.
12. When two or more cabinets are
installed next to each other, secure
them together with a ganger plate.
Fasten a ganger plate to the cabinet
bottoms with two #8 x
5
/
8
” black
screws (Figure 6).
13. To install shelf dividers (optional),
first place the front hook of the
divider into the front slot of the
shelf. Then rotate the rear of the
divider down until the the tab snaps
into the vertical slot in the cabinet
back (Figure 6). To remove the
divider, press lightly on the cabinet
back to release the rear tab and
rotate it out.
Figure 6
on-module
overhead
on-module
mounting bracket
shelf divider
(optional)
ganger
plate
#8 x /
5
8
"
black screw
antidislodgement
tooth
front slot
front hook
vertical slot
Detail A
