Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
11
Radiused Front, Low & Regular
Shelf
1. Position the two shelf side panels
with the support flanges facing
inward. Locate the side panels
at the height that is desired on
the panel. The side panels have
integral teeth that engage in the
furniture hanging slots in the
panel frame (Figure 1).
2. Engage the antidislodgement
tooth into the panel frame by
holding the side panel out from
the bottom about 30
°,
then rotate
the side panel down to engage all
the remaining teeth. When all the
teeth are engaged, press down
on the side panel to lock in place.
Repeat for the second side panel
(Detail C).
Note:
Using the top most slot
in the frame allows the unit to be
mounted flush with the top of the
panel.
Caution:
To remove the side
panel from the panel frame, push
from the bottom of the panel
straight up, approximately
1
/
4
”.
Grasp the bottom of the side panel
and rotate out toward you above
30°. Pull the side panel straight
out. Do not force the side panel.
Damage to the top tooth may
result.
Note:
Failure to properly install
shelf side panel may cause shelf
failure and personal injury.
3. Place the side flanges of the
bottom shelf over the support
flanges on the bottom of the side
panel (Figure 2).
antidislodgement
tooth
panel frame
Detail C
Figure 1
upmount bracket
(right-hand)
shelf side
panel
lower shelf
side panel
shelf side
panel
lower side panel
support flange
panel frame
Figure 2
support
flange
shelf side
panel
bottom
shelf
