Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
cabinet back
stud
side panel
flange nut
off-module
mounting bracket
Figure 1
on-module
mounting bracket
Figure 2
bottom shelf
side flange
lower side panel
support flange
Overhead Cabinet, Off-Module
and On-Module Mounted Brackets
Assembly
Note:
The following overhead
cabinet assembly steps refer to both
off-module and on-module cabinet
types. The type of mounting bracket
used determines the type of cabinet
being assembled. Also, if cabinets
are being pre-assembled and cabinet
type (off-module or on-module) is
to be determined at a later time, the
mounting brackets may be installed
at a later time.
1. Assemble the cabinet back, side
panels and mounting brackets
(off-module or on-module) together
by inserting the holes in the side
panels (with support flanges facing
inward) and mounting brackets
through the studs on the cabinet
back. Loosely fasten the parts
together with six flange nuts as
shown. To avoid scratching side
panels during bottom shelf assembly
(step two), do not tighten flange nuts
at this time (Figure 1).
2. Set the bottom shelf into position
by locating the side flanges of the
bottom shelf over the lower support
flanges of the side panels (Figure 2).
