4
Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
the installation of the door stop.
Remove the two rear #8 x
3
/
8
” screws
(installed above). Press #8 x
3
/
4
”
self-tapping screws through each
door stop and fasten the door stops
to the flipper door racks on each side
of the overhead where the two rear
screws were removed (Figure 4).
3. Press the bottom shelf down and
adjust until the four screw holes in
the bottom shelf side flanges are
visible through the slots in the side
panel lower support flanges. From
under the cabinet, install four
#8 x
3
/
8
” self-tapping screws through
the slots in the side panel support
flanges. Do not tighten completely. At
the lower rear of the cabinet, install
two #8 x
3
/
8
” self-tapping screws
through the back and into the shelf.
Do not tighten completely (Figure 3).
4. Place the overhead top assembly
over the upper support flanges of the
side panels. Tap the top down into
place and align the round front edge
with the matching radius on the side
panel. Install and tighten four
#8 x
3
/
8
” self-tapping screws through
the four larger oblong holes in the
rack and pinion door mechanism
inside the top assembly (Figure 4).
5. The recessed door can now be
pulled out and lowered to it’s closed
position. Adjust the bottom shelf so
the door hangs straight and flush
with the end panels. Tighten the four
screws under the bottom shelf at this
time. Using the door lock key (taped
to the inside of the top assembly for
shipping), engage the lock cam into
the locked position by turning the
key clockwise.
6. After the top and shelf have been
checked for proper alignment tighten
all hardware.
Note:
For those users who wish
to retain the key in the lock when
storing the recessed door, there
is a set of door stops that may
be installed to prevent door from
opening past the key. If the door
is opened with the key in the lock,
damage to the overhead cabinet and/
or a key broken off in the lock may
result without door stops.
7. To install recessed door stops,
open and store recessed door. Next,
pull door out about four inches,
enough to avoid interference with
Figure 3
bottom shelf
#8 x /
3
8
"
self-tapping screw
side panel
lower support flange
#8 x /
3
8
"
self-tapping screw
Figure 4
#8 x /
3
4
"
self-tapping
screw
door stop
(optional)
overhead top
assembly
side panel
upper support flange
rack and pinion
mechanism
#8 x /
3
4
"
self-tapping
screw
