Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
9
Off-Module Mounted Cabinets
4. Off-module shelves can only be
hung with the top aligned to a 12”
tile. To make hanging the overhead
easier, remove the top cap or tile
directly above the overhead. With
the overhead locks pulled out
(toward the front of the shelf), hang
the top and bottom of the mounting
bracket into the tracks of the panel’s
horizontal rail. Make sure the shelf
is hanging on the horizontal rail
and not on the tile. After the shelf
is hung in the track, move it to the
desired position by gently lifting up
while sliding it. Secure the shelf on
the tracks by pressing the overhead
locks into the track (Figure 4).
Caution:
To remove the shelf
assembly from the panel, push the
bottom of the shelf straight up about
1
/
4
” and rotate the bottom out toward
you to about 30°. Pull the shelf
straight out and down. Do not force
the side panel, damage to the top
tooth may result.
5. When two or more shelves are
installed next to each other, secure
them together with a ganger plate.
Fasten a ganger plate to the shelf
bottoms with two #8 x
5
/
8
” black
screws (Figure 4).
6. To install shelf dividers (optional),
first place the front hook of the
divider into the front slot of the shelf.
Then rotate the rear of the divider
down until the the tab snaps into the
vertical slot in the shelf back
(Figure 4). To remove the divider,
press lightly on the shelf back to
release the rear tab and rotate it out.
Figure 4
off-module
shelf
#8 x /
5
8
"
black screw
ganger
plate
shelf divider
(optional)
overhead lock
off-module
mounting
bracket
12 tile
"
horizontal tracks
front slot
front hook
vertical slot
