Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
5
Off-Module Mounted Cabinets
8. Off-module mounted cabinets can
only be hung with the top aligned
to a 12” tile. To make hanging
the overhead easier, remove the
tile or top cap directly above the
overhead. With the overhead locks
pulled out (toward the front of the
cabinet), hang the top and bottom
of the mounting bracket into the
tracks of the panel’s horizontal rail.
Make sure the cabinet is hanging
on the horizontal rail and not on
the tile. After the cabinet is hung
in the track, move it to the desired
position by gently lifting up while
sliding it. Secure the cabinet on the
tracks by pressing the overhead
locks into the track (Figure 5).
Caution:
To remove the cabinet
assembly from the panel, push the
bottom of the cabinet straight up
about
1
/
4
” and rotate the bottom out
toward you to about 30°. Pull the
cabinet straight out and down. Do
not force the side panel, damage to
the top tooth may result.
9. When two or more cabinets are
installed next to each other, secure
them together with a ganger plate.
Fasten a ganger plate to the cabinet
bottoms with two #8 x
5
/
8
” black
screws (Figure 5).
10. To install shelf dividers (optional),
first place the front hook of the
divider into the front slot of the
shelf. Then rotate the rear of the
divider down until the the tab snaps
into the vertical slot in the cabinet
back (Figure 5). To remove the
divider, press lightly on the cabinet
back to release the rear tab and
rotate it out.
Figure 5
off-module
overhead
12 tile
"
horizontal
rails
mounting
bracket
overhead
lock
shelf divider
(optional)
ganger
plate
#8 x /
5
8
"
black screw
front slot
front hook
vertical slot
